Vertical shaft sand making machine adjusts the output size
The vertical shaft sand making machine can adjust the discharging particle size in a variety of ways, such as adjusting the gap between the impact plate and the grinding cavity, adjusting the impeller speed, or adjusting it through hydraulic and mechanical, etc. The hydraulic adjustment system can be effectively operated through the button The adjustment of the gap is completed, and the production and processing of different grit sizes can be realized by adjusting the speed of the impeller.
In addition, when adjusting the size of the discharge opening, it is necessary to use the adjustment ring and the serrated thread between the falling cone liner and the supporting sleeve to complete. After the adjustment ring is screwed into the thread, the fixed umbrella plate is raised or lowered by rotating the adjustment ring. To adjust the size of the discharge opening.
Discharge display of vertical shaft sand making machine
Matters needing attention when adjusting the discharge size:
When adjusting the size of the discharge port, it should be noted that the size of the discharge port cannot be smaller than the specified size. If the thread is clogged, the adjustment plate will be difficult to rotate. At this time, lubrication can be added to lubricate the blocked ore inside the sand making machine, and then rotate Adjust the ring.
Phone: +86 17719851781
whatsapp: +86 17719851781