Sand making machine installation process and precautions
The status of the sand making machine in the sand making production line is now one of the best. If it is not installed correctly during the installation process, it will not only cause the entire production line to fail to work, but also bring harm to the machine itself. What is serious is that it will pose a personal threat to the operators of the sand making machine.
Before trial operation of the sand making machine equipment, be sure to add lubricating oil again, and check whether the connection between the parts is firm and reliable, whether there are foreign objects on the impeller, and whether the motor wiring is correct. After operation, if there is any abnormality, stop the operation immediately.
Before installing the sand making machine equipment, first check according to the packing list to check whether the various parts are worn or not during transportation and whether they are complete. During installation, the sand making machine should be leveled so that its main shaft is perpendicular to the horizontal plane. Appropriate space should be left above and on both sides of the sand making machine for hoisting and maintenance. After the installation is completed, a comprehensive inspection should be carried out, such as whether the lubricating oil pipe is firmly connected.
When installing the sand making machine, pay attention to the following: Since the sand making machine vibrates during work, the machine should be installed on a concrete foundation. In order to reduce vibration, noise and the impact on the foundations of nearby buildings and structures, the sand making machine and Hardwood pads, rubber bands or other shock-absorbing materials are used between the concrete foundations. The basic discharging trough should be laid with a layer of metal plate and have a sufficient inclination angle (it should be determined according to the fluidity of the material, not less than 50°), so as not to hinder the smooth discharge of the crushed product.
The size of the discharge opening should be adjusted according to the required product granularity. When adjusting, loosen the T-line bolts and tension springs. Use jacking bolts to open the adjusting seat, insert or remove gaskets of corresponding thickness, and then retract the jacking bolts, and the adjusting seat will be close to the ear seat of the frame under the weight of the movable jaw, and the gasket group will be pressed at the same time. Get together. Afterwards, adjust the spring preload to ensure that the thrust plate and the thrust plate pad are in close contact when the machine is working. However, the pre-pressure should not be too large, as long as there is no percussive sound, the adjusting seat is finally locked.
Phone: +86 17719851781
whatsapp: +86 17719851781