Improved method of gear roller bearing components of classifying crusher
The toothed roller bearing component is an important working part of the grading crusher. Its main function is to bear the dead weight of the crushed toothed roller and the dynamic load generated when crushing the material. In the working process of the crusher, there are many problems in the gear roller bearing components, which have a great impact on the normal operation of the crusher. This article will summarize the problems existing in the use of gear roller bearing components, and propose effective improvement measures to solve the problems.
The main problems in the use of gear roller bearing components are:
①The lubricating oil circuit is too tortuous, and the oil circuit plugging is designed to block the process hole, but sometimes the seal is not reliable, and the grease cannot completely enter the bearing cavity, causing the bearing to run in a poorly lubricated state, causing premature damage to the bearing .
②When installing, it is necessary to heat the bearing, bearing sleeve and seal ring at the same time after they are installed in place, and then install them on the gear roller shaft at the same time. The seal ring will age during the heating process, causing seal failure during use.
③ When the bearing is damaged after long-term use and needs to be replaced, the shoulder size on the bearing sleeve is too small to install and remove tools, which makes it difficult to replace the bearing.
④The bearing will generate heat after running for a long time, causing internal pressure in the bearing cavity, and grease cannot enter. In order to realize the normal lubrication of the bearing, it is necessary to manually open the pressure relief plug to release the internal pressure, which increases the hidden danger of unreliable lubrication. .
⑤The labyrinth seal is not filled with grease, and the finer dust in the material crushing area will damage the seal ring.
In view of the above problems, the gear roller bearing components can be improved. The improvements include:
1) The oil pipe joint is installed on the bearing end cover instead of the bearing sleeve, which can effectively solve the problem of poor bearing lubrication caused by the inability of grease to enter the bearing cavity.
2) Design the original bearing sleeve into two parts (bearing sleeve and labyrinth ring) and then fasten them with bolts. When installing the bearing on the toothed roller shaft, you only need to install the labyrinth ring and the sealing ring in place, and then heat the bearing sleeve and the bearing and install it on the toothed roller shaft at the same time, avoiding the aging of the sealing ring during the heating process. Problem, prolonged the life of the sealing ring.
3) Reduce the maximum outer diameter of the seal ring to leave enough space for maintenance to facilitate installation and removal of tools. When the bearing is damaged, remove the bearing seat, then remove the bolts, bearing sleeve and bearing end cover, use a disassembly tool to remove the damaged bearing and replace it, which increases the maintainability of the bearing.
4) Machining a Φ2 oil outlet on the labyrinth ring can solve the problem of internal pressure in the bearing cavity after the bearing is running for a long time, and the lubricating grease is filled in the labyrinth seal to make the labyrinth seal more reliable and effective Increase the life of seals and bearings. With PLC controlled automatic timing lubrication system, there is no need to worry about excessive oil output from the Φ2 oil outlet on the labyrinth ring.
After the improvement of the gear roller bearing components, the accidents of bearing and sealing ring damage in the actual use process are significantly reduced, and the daily maintenance of the grading crusher is reduced at the same time.
Phone: +86 17719851781
whatsapp: +86 17719851781